How to Choose a Power Supply for LED Strip
Many people know that connect LED strips
directly into the outlet should not be - it will burn immediately. To do this,
use a power supply for LED strip, and choose how to calculate the power and
ribbon, we'll tell you in this article.
In total there are basically two: the power
supply for LED 12W tape and 24 watts. We recommend using 12W, because they cost
much less at the same time carry out such functionality. Power 12W is considered
optimal, they can be easily found at any market. To install at home is better
not find the device. If you connect a large tape, then you will come in handy
at 24 watts, as a rule, to illuminate a large area of a stretch ceiling it will
fit just right. If you want to do without a block, then think about the LED
ribbon RGB on line 220. BTW, you can select the power supply for LED Strip at
Banggood. Besides, you can easily get other lighting and lighting accessories (e.g.
key
ring light) there with high quality and reasonable prices.
Let's try to make the calculation on the
basis of one meter LED strip SMD 5050. The table shows the value of 7.2 watts.
Next, we determine the length of our tape, take, for example, the tape 10 meters.
Perform simple multiplication: 10 meters multiply by 7 watts. It turns out 72
watts - a power which should have a block. They can be found in any store, they differ
only in the installation process. For example, one can only be installed in a
dry room, and the other can be installed even in the bathroom. They are
considered the most popular although many people do not even use them to full
functionality. Maximum power of this unit is 75 watts. This capacity is enough
for an average LED strip. This unit can be used for lighting LED ceiling ribbon.